baterie sram v tranmission přehazovačce

6 nepřečtených
  • koloolaf

    Koupil jsem přehazovačku sram x0 transmission a po instalaci jsem zjistil že ze tří baterii mě jede jen jedna ,jak je to možné setkal se někdo s podobným problémem ?Samozřejmě že jsou nabité na silničním kole fungují na sramu force normálně,děkuji za informaci.R

    0 0
    • Kouba_2005  

      Ne, všechny baterie mi fungují všude.

      Ale v Brně je možný všechno.

      5 0
    • becis  

      Co znamená „jede jen jedna“? Myslíš tím že svítí červeně když ji dáš nabíjet? To se mi stalo také, stačí postupovat podle návodu:

      Manual Wake Up Procedure

      If your charger is not capable of trickle charging or the trickle charge procedure did not wake the battery, perform the following procedure:

      1. Plug the battery charger into the USB charging port of a computer.
      2. Place the battery into the battery charger and wait for the charger LED to respond.
      3. If the LED responds red, remove the battery from the charger and wait for the LED to turn off.
      4. Place the battery on the charger again and wait for the LED to respond.
      5. Repeat steps 2–4 for a total of 10–15 cycles or until the LED turns yellow.

      If the LED remains red after 10–15 attempts, the battery can not be recovered and must be replaced.

      Zrovna dneska jsem to dělal s jednou starou baterkou a funguje to.

      1 0
    • Kysky  

      Některé baterky staršího data výroby nefungují na transmissionu

      1 0
      • koloolaf  

        tak to bude asi tento případ,protože na silniční sade force mě to jede normálně

        0 0
        • Kysky  

          Jaké je číslo pod QR kódem na straně, co jsou konektory?

          0 0

Nová reakce na zakládající

Pro zobrazení diskuse se prosím přihlaste nebo zaregistrujte.